SAF OPAL Ethernet IP Interface MS6 SERIES Manual do Utilizador Página 1

Opal Pro to SAF GlobalData Page 1 Opal Pro MS6 SERIES SAF GlobalData Interface Users Manual Revision 1.00

Opal Pro to SAF GlobalData Page 10 I/O Configuration The Opal Pro supports 4 input words and 51 output words. Their description is as follows: Inp

Opal Pro to SAF GlobalData Page 11 Output Words Name Description Word 1 Status Bit 0 – Ready to Run (drive is enable and has 3 phase power) Bit 1 –

Opal Pro to SAF GlobalData Page 12 1.06 (Word 9) Analog Input Analog input value in Volts X 100 1.07 (Word 10) Relay Status Status of the Relay Outpu

Opal Pro to SAF GlobalData Page 13 12.01 (Word 28) Analog Output 16 = Current Reference 17 = Current Feedback 18 = Overload level 19 = Phase Angle 13

Opal Pro to SAF GlobalData Page 2

Opal Pro to SAF GlobalData Page 3 FOR YOUR SAFETY Only qualified personnel should install this equipment, after first reading and understandin

Opal Pro to SAF GlobalData Page 4

Opal Pro to SAF GlobalData Page 5 Table of Contents INTRODUCTION ...

Opal Pro to SAF GlobalData Page 6 Opal Pro to Mod TCP Introduction The Opal Pro can be monitored and controlled over a EtherNet communication network

Opal Pro to SAF GlobalData Page 7 LED Indicators Two bi-colour (red/green) LED indicators are mounted beside the network connector. The upper LED i

Opal Pro to SAF GlobalData Page 8 Opal Pro Parameter Settings The parameters in the Opal Pro used to configure the Ehernet interface card (group 14)

Opal Pro to SAF GlobalData Page 9 15.04 Comm Fault Enable Disable Enable – Opal Pro trips out on a communication fault Disable – Nothing happens on a